cryptonews24

Keep ETH for the token you receive

Before swapping into an Ethereum token, leave some ETH in the destination wallet for the transaction that spends it. A cross-chain swap can deliver the token, but an ERC-20 transfer still needs ETH for Ethereum gas; without it, the token can sit in your wallet until you add ETH.

Choosing a route answers which networks and assets fit; how thor swap route choice works covers that decision, while the next question is how much native ETH to keep available. A thor swap can bring assets across chains in one flow, but that does not remove Ethereum’s gas requirement for later transactions.

How much ETH should you leave?

Keep enough for the next transaction you expect to make, plus a little room for a higher fee estimate. A standard ETH transfer uses 21,000 gas units, while an ERC-20 token transfer often estimates around 65,000; the actual amount depends on the contract and transaction.

Gas units measure computation, not ETH. The fee is the gas used multiplied by the price per unit, usually quoted in gwei. For example, at an estimated 20 gwei, a 65,000-unit token transfer would cost about 0.0013 ETH. Ethereum’s documentation explains the calculation and why fees change with network demand.

If you may need to approve a token before using it in a decentralised app, allow for that too. An approval is a separate contract transaction, so it can require another gas payment before the swap or deposit itself. Check the wallet’s estimate for each action rather than assuming one reserve covers every step.

How do you estimate the reserve before swapping?

Use the destination wallet and the likely next action to make the estimate. Check the current fee estimate for a token transfer, then consider whether you will also need an approval or another contract interaction. Keep that amount in native ETH on the same Ethereum address that will receive the token.

A common mistake is to send nearly all available ETH into the swap because the destination token is the main goal. The fix is to account for the later gas payment before choosing the amount to swap. If the route delivers a token but leaves no ETH in the destination wallet, you may need a separate transfer of ETH before you can move or use that token.

Gas estimates can rise when Ethereum is busy, and a more complex contract call can use more gas than a basic transfer. Recheck the estimate just before acting; if you plan several transactions, budget for each one rather than multiplying a single transfer estimate blindly.

Can the received token pay Ethereum gas?

No. Ethereum transaction fees are paid in ETH, including fees for sending ERC-20 tokens. The token balance can be valuable and visible in the wallet, but it cannot cover the gas needed to move itself. Keep ETH in that same wallet address, or arrange to add ETH before you need to transact.

What if I already swapped and have no ETH left?

The token remains in the wallet, but you will need ETH on Ethereum to send it or interact with a contract. Arrange a small ETH transfer to that address, then check the wallet’s current estimate before retrying. Make sure the ETH arrives on Ethereum; ETH on another network will not pay Ethereum gas.

Decision rule: estimate the next Ethereum action first, then leave enough ETH in the receiving wallet to pay for it.